Canon BJC-230 Printer

BJ-230 Printer

 

General Info:

Alternative Drivers

Drivers you can use if the BJ-230 driver is not available.

Cartridge

Cleaning Print head

Self Test

Ripple Test : The ripple test prints the full character set in a staggered form as it scrolls down the page. Hold down the ON LINE and PRINT MODE. Switch on the printer while holding down these switches until the beeper sounds. To quit the test press the two buttons for a second. Note: This test is not available in manual feed mode (with the paper selection lever to the front).

All Modes Test : The All Modes test prints a series of characters in different fonts and sizes. Hold down the ON LINE switch and turn the power on. When the beeper sounds release the ON LINE switch. To quit this test, press the ON LINE switch for one second. The self print mode will be canceled and the paper will be ejected. Note: This test is not available in manual feed mode (with the paper selection lever to the front).

Serial Number

Location - Cream colored label on the back of the printer near the power cord
Prefixes - EAU...

Special Paper

 

Known Issues

Printing Gibberish When Attached to a Packard Bell PC

If the printer is attached to a Packard Bell 9000 Series PC, then go into the Control Panel and then Fonts, and look for the Font WPBOXDRAWING. If it is there, then delete it. Also check that the Canon printer is set as the default printer.

Printing on A3 size paper will not work with any of the emulations in the manual.

Obtain updated drivers from Canon.

Print head moves, but nothing prints

This usually occurs when a new printer cartridge has been inserted. Run the print head cleaning process which should always be run when a new cartridge is inserted. Place a piece of kitchen towel over the print head and blow in the hole located on the side of the print head. This should force ink through the print head onto the towel. Dab the cartridge with a damp cloth to clear the blockage. Re-seat the cartridge to ensure the connections are correct. Ensure that the printer is switched off correctly. Use the switch on the printer, not the wall socket. This will ensure the print head is closed correctly and does not block up or dry out.

The printer does not print

There are many reasons why it may not print. Listed below are some of the tests you can perform. Run a self test to establish printer is a working unit. If this does not work the printer is faulty. Exit to DOS and print out a text file. EG PRINT AUTOEXEC.BAT. This should then print to the printer. If it does not either there is a printer port, computer LPT1 port or printer cable problem. Exchange the cable and try again. Test the printer on another computer. If it does print it is a software problem. If rubbish is printed from the DOS prompt. Again it could be printer port, computer LPT1 port or printer cable problem. exchange the cable and try again. Test the printer on another computer. Ensure that the printer is plugged in and connected correctly.

Text is split

Other symptoms of this problem white lines in text italicized. This should be a driver problem Try a different printer driver. Disable the fast direct printing to port in Print Manager. Clean the print head as listed above.

Paper error light comes on when switching on printer

Take any paper out of the printer and start the printer again. Insert the paper and press on line. Ensure the paper is inserted correctly. Far enough over to the left if no sheet feeder attached over the right if the sheet feeder attached. Check the DIP switches are set correctly and the correct emulation has been set on the PC.

Power light flashes and the printer does not work

Try removing and reinstalling the cartridge.

 

Error Codes

Power

Online

HS

HQ

Error

Beeps

Cause

Solution

Off

Off

Off

Off

Off

 

No Power

Turn on power / plug in AC cord

On

 

 

 

On

3

Paper Pickup Error or out of paper

Add Paper or clear paper jam and press Online

On

 

 

 

On

4

Paper Jam

Clear paper jam and press Online

On

Flashing

Flashing

Flashing

On

3

Carriage Control Error

Requires Service

On

Flashing

Flashing

Flashing

On

4

Cleaning Error

Remove Cartridge and Check Nothing is Blocking the Path of the Cartridge. If not then printer Requires Service

On

Flashing

Flashing

Flashing

On

5

Temperature Sensor Error

Requires Service, However it may be resolved by simply replacing the cartridge

On

Flashing

Flashing

Flashing

On

6

ROM/RAM Error

Requires Service : Also try unplugging the printer for 60 seconds

 

DIP Switches

Dip switches are located on the top of the printer, next to the power switch and underneath a small flap.

BJ Mode

Switch

Function

On

OFF

Factory
Setting

1

Horizontal Print Position

A4

Letter

OFF

2

Text Scale Mode

Enabled

Disabled

OFF

3

Ù/>

Reduction Mode

Enabled

Disabled

OFF

4

Page Length

12 Inches

11 Inches

OFF

5

Character Set

Set 2

Set 1

OFF

6

Automatic Carriage Return

LF + CR

LF only

OFF

7

Automatic Graphics Mode (AGM)

Enabled

Disabled

OFF

8

Not Used

 

 

OFF

9

Code Page

850

437

OFF

10

Buffer Size

Receive 9.4 KB
Download 41.0 KB

Receive 50.4 KB
Download OKB

OFF

11

Not Used

 

 

OFF

12

Printer Control Mode (DOS)

Epson LQ-510

BJ-10/IBM X24e

OFF

LQ MODE (Epson LQ-510)

Switch

Function

On

Off

Factory
Setting

1

Horizontal Print Position

A4

Letter

OFF

2

Text Scale Mode

Enabled

Disabled

OFF

3

Reduction Mode

Enabled

Disabled

OFF

4

Page Length

12 inches

11 inches

OFF

5

Character Set

Set 2

Set 1

OFF

6

Int'l Character Set

See Table 1

OFF

7

Int'l Character Set

See Table 1

OFF

8

Int'l Character Set

See Table 1

OFF

9

Typeface

See Table 2

OFF

10

Typeface

:10.Table 2

OFF

11

Typeface

See Table 2

OFF

12

Printer Control Mode (DOS)

Epson LQ-510

BJ-10/IBM X24e

ON

Table 1 : International Character Set

Country

Switch 6

Switch 7

Switch 8

 

 

USA

OFF

OFF

OFF

UK

OFF

OFF

ON

Germany

OFF

ON

OFF

France

OFF

ON

ON

Denmark

ON

OFF

OFF

Sweden

ON

OFF

ON

Italy

ON

ON

OFF

Spain

ON

ON

ON

Table 2 : Typeface

Typeface

Switch 9

Switch 10

Switch 11

Roman

OFF

OFF

OFF

Sans Serif

OFF

OFF

ON

Draft

OFF

ON

OFF

Courier

OFF

ON

ON

Prestige

ON

OFF

OFF

Script

ON

OFF

ON

Orator

ON

ON

OFF

Orator-S

ON

ON

ON